Siemens Simatic S7-300 31xC Series User Manual


First Steps in Commissioning CPU

31xC: Positioning with digital output
_
_________________
_
_
_________________
_
_
_________________
_
_
_________________
_
SIMATIC
S7-300
First Steps in Commissioning CPU 31xC:
Positioning with digital output
Getting Started
08/2011
A5E00105533-03
Introduction
1
Preparation
2
Learning units
3
Further Information
4

Siemens Simatic S7-300 31xC Series Specifications

General

Brand	Siemens
Model	Simatic S7-300 31xC Series
Category	Computer Hardware
Language	English

Summary

Introduction

Preparation

Scope

Details the CPUs covered by these instructions and the required firmware versions.

Requirements

Lists the necessary hardware and software for the S7-300 station setup.

Layout of the Example

Provides an overview of the sample setup with labeled components and connections.

Learning Units

1. Step: Wire the CPU

Step-by-step guide for wiring the CPU, power supply, encoder, and relay circuit.

2. Step: Installing the Sample Project

Instructions for installing the sample project from CD or via the Internet.

3. Step: Setting Parameters

Guide to configuring positioning parameters within SIMATIC Manager and adapting addresses.

4. Step: Linking Blocks to the User Program

Process for copying and downloading program blocks from the PG to the CPU.

5. Step: Carrying Out a Dry Run

Instructions for testing drive functions in Jogging and Incremental approach modes.

Further Information

Diagnostics/Correction of Errors

Guidance on analyzing and correcting errors related to operator input or configuration.