To Next PageTo Next Page
Need help?Do you have a question about the Siemens SIMATIC S7-400 CP 440 and is the answer not in the manual?
General| Product Type Designation | CP 440 |
|---|---|
| Product Type | Communication Processor |
| Series | SIMATIC S7-400 |
| Supply Voltage | 24 V DC |
| Number of Interfaces | 1 |
| Communication Interface | Point-to-point |
| Protocols Supported | ASCII, 3964(R), RK 512 |
| Power Supply | Via backplane bus |
| Operating Temperature | 0 °C to 60 °C |
| Interface Type | RS-422/485 |
Lists the necessary hardware and software components for setting up a connection.
Details the process of data transfer using the ASCII driver.
Explains the data transfer process using the 3964(R) protocol.
Lists the sequential steps required for commissioning the CP 440.
Provides instructions for physically installing the CP 440 into the rack.
Explains the process of configuring the CP 440 within the STEP 7 software.
Details how to set protocol-specific parameters for the CP 440.
Guidance on developing user programs that utilize the CP 440.
Steps for testing and verifying the physical interface connection.
Detailed steps for installing and removing the CP 440 module.
How to assign parameters to the CP 440 using STEP 7 software.
Explains the parameters required for various communication protocols.
Covers essential configuration settings for the CP 440.
Practical guidance on parameterizing and utilizing function blocks.
Details the phases and procedures involved in starting up the CP 440.
Overviews the diagnostic capabilities available for the CP 440.
How to interpret status information from the CP 440's LEDs.
Explains error messages and codes associated with function blocks.
How to access and interpret the CP 440's internal diagnostic log.
