Siemens Simatic S7-300 314C-2 PN/DP User Manual


First Steps in Commissioning CPU

31xC: Positioning with digital output
_
_________________
_
_
_________________
_
_
_________________
_
_
_________________
_
SIMATIC
S7-300
First Steps in Commissioning CPU 31xC:
Positioning with digital output
Getting Started
08/2011
A5E00105533-03
Introduction
1
Preparation
2
Learning units
3
Further Information
4

Siemens Simatic S7-300 314C-2 PN/DP Specifications

General

Article number	6ES7314-6EH04-0AB0
Digital Inputs	24
Digital Outputs	16
Analog Outputs	2
Power Supply	24 V DC
Number of DP masters	1
Number of high-speed counters	6
CPU Type	CPU 314C-2 PN/DP
Integrated Interfaces	1x MPI/DP, 1x PROFINET
Analog Inputs	5
Number of PN IO devices	128
Integrated Functions	Positioning
Communication Functions	PROFIBUS, PROFINET
Operating Temperature	0 to 60 °C
Weight	0.5 kg

Summary

Introduction

Preparation

Scope

Specifies the applicable CPUs and required firmware versions for the manual's procedures.

Requirements

Details the necessary hardware, software, and system prerequisites for successful implementation.

Layout of the example

Visual representation of the sample setup, including components and their labeling.

Learning units

1. Step: Wire the CPU

Step-by-step guide for connecting the CPU, power supply, and encoder, with pin details.

2. Step: Installing the sample project

Instructions for installing the sample project from either a CD or over the internet.

3. Step: Setting parameters

Guide to configuring the CPU's positioning parameters using SIMATIC Manager and HW Config.

4. Step: Linking blocks to the user program

Process for copying and downloading S7 program blocks from PG to CPU.

5. Step: Carrying out a dry run

Testing procedures for the positioning function using 'Jogging' and 'Incremental approach' modes.

Further Information

Diagnostics/Correction of Errors

Guidance on analyzing and resolving operational errors, faulty wiring, and configuration data issues.