Siemens Simatic S7-300 314C-2 PN/DP - Default Chapter; Table of Contents

First Steps in Commissioning CPU 31xC: Positioning with digital output
Getting Started, 08/2011, A5E00105533-03
3
Table of contents
1 Introduction................................................................................................................................................ 5
2 Prepar
ation................................................................................................................................................ 7
3 Learnin
g units .......................................................................................................................................... 11
3.1 1. Step: Wire the CPU
..................................................................................................................11
3.2 2. Step: Installing
the sample project...........................................................................................14
3.3 3. Step: Setti
ng parameters .........................................................................................................15
3.4 4. Step: Link
ing blocks to the user program ................................................................................16
3.5 5. Step: Carrying out a dry run
.....................................................................................................17
4 Furt
her Information .................................................................................................................................. 19