Point-to-point connection CP 440 Installation and Parameter Assignment
Manual, 09/2007, A5E00057742-03
57
Commissioning the CP 440
3
Step sequence
Before starting up the CP 440 you will need to perform the following steps in the specified
sequence.
1. Mounting the CP 440
2. Configuring the CP 440
3. Assigning Parameters to the CP 440
4. Backing up Configuration Data
5. Creating a User Program for the CP 440
6. Commissioning the Physical Interface
Mounting the Communication Processor
Mounting the communication processor involves inserting it into the mounting rack of your
programmable controller.
Connecting the CP 440 to the Communication Partner
The connection to your communication partner is made using the cable.
Configuring the Communication Processor
The CP configuration includes its entry in the configuration table. Configure your
communication processor using the STEP 7 software.
Assigning the Communication Processor Parameters
Assigning parameters to the communication processor involves creating the specific
parameters of the protocols. Perform parameter assignment of the communication processor
from the programming interface Point-to-Point Communication, Parameter Assignment.
Backing up Configuration Data
A backup of CP parameter data includes the storage of parameters, their download to the
CPU and transfer to the CP. Backup your CP configuration using the STEP 7 software.
该文档是极速PDF编辑器生成，
如果想去掉该提示,请访问并下载：
http://www.jisupdfeditor.com/
To Next Page
Loading...
