Operating the Control Panel
5.9 Service and Commissioning
Unified Comfort Panels
Operating Instructions, 03/2020, A5E46641217-AA
113
Backup files
● The list shows all backups that can be loaded to the HMI device.
Select the desired backup from the list.
● "Restore": Button to start the restore process.
The HMI device restarts after the "Restore" button is pressed. The restore process then
begins.
Do
not switch off the HMI device during the restore process and do not disconnect the
data source from the HMI device.
During the restore process, a dialog with a progress bar is displayed for each backup file
loaded.
The HMI device is restarted again after the completion of the restore process.
The main window of the Control Panel is displayed after the restart.
The data from the storage medium is now restored on the HMI device.
Note
System behavior when the process is interrupted
If the restore process cannot be completed due to a power failure or an interrupted data
connection, for example, the HMI device starts in maintenance mode and the factory settings
must be
restored.
See also
Resetting an HMI device to factory settings via ProSave (Page 133)
To Next Page
Loading...
