Need help?Do you have a question about the Siemens 6SL3210-1KE11-8UF2 and is the answer not in the manual?
General| Order Number | 6SL3210-1KE11-8UF2 |
|---|---|
| Degree of Protection | IP20 |
| Overload Capability | 150% for 60 s |
| Storage Temperature | -40°C to +70°C |
| Relative Humidity | 5% to 95% (non-condensing) |
Overview of PM240-2 Power Modules, detailing frame sizes and power ranges for different voltages and integrated filter options.
Details various Control Units (CU230P-2, CU240E-2, CU250S-2) and Control Unit Adapters (CUA, CUA20) for SINAMICS converters.
Presents Operator Panels like BOP-2 and IOP-2 used with SINAMICS converters for marine applications.
Overview of G120C compact converters, detailing voltage, frame size, power range, communication variants, and integrated filter.
Details ambient temperature considerations for marine applications, including potential derating.
Addresses the risk of condensation in marine environments and necessary protective measures.
States that the occurrence of salt mist is not permissible for components.
Explains vibration stress impact and the need for reinforced control cabinets and component separation.
Covers EMC immunity requirements for marine applications and device installation.
Discusses emitted interference requirements for devices and zones in marine power distribution.
Highlights marine power supply characteristics and compliance with marine standards for voltage/frequency deviations.
Defines control cabinet protection requirements against environmental factors and access to active parts.
Details reinforced control cabinet design for marine applications to withstand vibration stress, using Rittal TS8 as an example.
Explains how to install components like Control Units and Power Modules separately in control cabinets for marine use.
Describes installing BOP-2 or IOP-2 operator panels in control cabinet doors with door mounting kits for IP55 protection.
Covers control cabinet ventilation requirements for dissipating power loss, including air intake and discharge points.
Details connecting external 24-V-DC auxiliary power supplies for Control Units, emphasizing PELV and isolation requirements.
To Next Page