Commissioning
5.2 Applying supply voltage
PAC1020
38 Equipment Manual, 05/2020, L1V30610008B-01
5.2 Applying supply voltage
A supply voltage is required to operate the device. Please consult the Technical data
(Page 65) or the rating plate for the permissible supply voltage type and level.
The wrong system connection can destroy the device.
Failure to heed this warning can result in damage to the device and the system. The
minimum and maximum limits given in the technical data and on the rating plate must not
be exceeded even during startup or testing of the device.
5.3 Parameterizing the device
For commissioning the device, you must specify the operating parameters listed below in the
device settings:
• Basic parameters
The following settings are also useful:
• Language
• Device protection against manipulation
First commissioning
The language selection only appears:
• During first commissioning
• After a reset to factory settings
• After a firmware update
Select the required language and confirm your selection by choosing "OK".
The menu-based navigation of the device is available in four languages:
• English
• Portuguese
• Spanish
• Chinese
To Next Page
Loading...
