Need help?Do you have a question about the Siemens SENTRON 7KT PAC1600 and is the answer not in the manual?
General| Device Type | Power Monitoring Device |
|---|---|
| Measurement Parameters | Voltage, Current, Power, Energy, Frequency, Power Factor |
| Display | LCD |
| Mounting | Panel mounting |
| Mounting Type | Flush mounting |
| Product Type | PAC1600 |
| Current Input | Via external current transformers (CTs) |
| Measuring Range Current | 0 to 6 A |
| Accuracy Class | 0.5 |
| Communication Interfaces | Modbus RTU |
| Protection Class | IP20 |
| Operating Temperature | -10...+55 °C |
| Housing Protection Class | IP20 |
Covers product components, latest information, training, OSS, and qualified personnel.
Information on personnel qualified for operating the device safely.
Explains the grading of safety warnings (DANGER, WARNING, CAUTION, NOTICE).
Outlines Siemens' liability for the publication's content and accuracy.
Details the capabilities and measurement functions of the PAC1600.
Describes the current and voltage measurement capabilities.
Information specific to single-phase PAC1600 energy meters.
Explains how to operate the device using its keys.
Details how to configure device settings and parameters.
Explains how to operate the 80 A three-phase devices using keys.
Details configuration settings for 80 A three-phase devices.
Explains how to operate the 5 A three-phase devices using keys.
Details configuration settings for 5 A three-phase devices.
Guidance on choosing a suitable location for device installation.
Steps for installing and removing single and three-phase devices.
Critical safety information for connecting the device.
Demonstrates connections via Modbus RTU and other interfaces.
Procedure to verify correct device installation and wiring.
General introduction to commissioning and required conditions.
Guide to using Siemens software for device configuration.
Maps Modbus addresses to measured variables for communication.
Procedures for firmware updates, password recovery, and fault diagnosis.
Information on product warranty and end-of-life disposal.
Key technical data including input, environmental, and insulation specifications.
Explanation of device markings and compliance standards.
Physical dimensions for single and three-phase devices.
Information on handling sensitive electronic components.
Guidelines for setting up an ESD-safe workspace.
To Next Page