Description
3.6 Supporting software
7KT16 energy meter
66 Equipment Manual, 09/2020, 2514284147-04
Run wiring test
1. Call up the command menu. You can find more information in chapter Command menu
(Page 64).
2. Select command C.16 as described in the instructions in chapter Command menu (Page 64).
3. Check the following points:
– Reading of the three voltages
– Phase sequence
– Voltage unbalance
– Reverse polarity of one or more current transformers
– Mismatch between voltage/current phases
If the test is not successful, the display indicates the reason why it has failed.
3.6 Supporting software
3.6.1 powermanager
You can use the powermanager energy management software to acquire, monitor, evaluate,
display and archive the energy data of the measuring device.
powermanager functions
• Tree view of the customer's system (project tree)
• Measured value display with pre-defined user views
• Alarm management
• Demand curve
• Reporting, different report types (e.g. cost center report)
• Load monitoring of reaction plans
• Power peak analysis (available as of powermanager V3.0 SP1)
• Support of distributed plants (systems)
• Archiving system
• User administration
To Next Page
Loading...
