Siemens SENTRON 7KT PAC1600 - Parameterization; Set Parameters (Setup)

Description
3.5 Three-phase devices 5 A
7KT16 energy meter
48 Equipment Manual, 09/2020, 2514284147-04
3.5.4 Parameterization
3.5.4.1 Set parameters (setup)
Selecting a menu
1. In the standard measurement display, simultaneously press the "Increase" and "Decrease"
keys to call the main menu.
2. Select SET and press the "Next" key to open the settings menu.
The display shows the first menu level P01 on the top left with selection 01 flashing.
3. Use the "Increase" or "Decrease" keys to select the required menu (e.g. P01, P02, P03).
During the selection, the alphanumeric display shows a brief description of the currently
selected menu.
Simultaneously press the "Increase" and "Decrease" keys to exit the setting and return to
the measurement display.
Note
The following table lists the available menus, which vary depending on the device
versions. Not all codes are available with all devices.
Code
Menu
Description
P01
GENERAL
Specification of the system
P02
OTHER
Language, brightness, display, etc.
P03
PASSWORD
Password activation
P04
INTEGRATION
Integration times
P05
HOUR COUNTER
Hour counter settings
P07
COMMUNICATION
1)
Communication settings
P08
LIMIT THRESHOLDS
Limit values
P09
ALARMS
Alarm messages
P11
ENERGY PULSES
2)
Configuration of energy pulses (S0)
P13
INPUTS
Programmable inputs
P14
OUTPUTS
2)
Programmable outputs
1)
On M-BUS and RS 485 devices only
2)
On S0 devices only