Description
3.3 Single-phase devices
7KT16 energy meter
20 Equipment Manual, 09/2020, 2514284147-04
5. Press the front key (> 3 s) to confirm and return to the parameter code selection.
ESC appears on the display after the last parameter code.
6. Press the front key (> 3 s).
The parameters are saved. The system resumes normal operation.
3.3.2 Advanced functions
Procedure
1. Press the front key from any display (> 5 s).
– If password protection is activated, PASS appears on the display. Proceed to point 2
(password entry).
– If password protection is deactivated, (factory setting, default password = 0000),
proceed to point 5 (function selection).
2. Release the key.
The device shows 0000 after approx. 2 to 3 seconds. The device is waiting for the
password to be entered.
3. Enter the password. Press the front key to increase the flashing digit in each case.
After 3 seconds, the entry field jumps to the next position.
4. After entering the password, press the front key to confirm.
– If the password is incorrect, PASS Er appears on the display and the normal display
reappears.
– If the password is correct, proceed to the next point.
5. The first entry in the following list of functions appears on the display:
– CLEAR P: Clear partial energy meters
– CLEAR h: Clear partial hour counter (if activated)
– CLEAR d: Clear maximum demand values (if activated)
– SETUP: Parameter programming (setup)
– INFO: Revision and checksum of internal software
– ESC: Return to normal display
Press the front key briefly to scroll through the list.
6. To select a function, press the front key for > 3 s while the function is visible on the display.
Note
If you keep the front key pressed for longer than 60 s, the menu closes automatically.
To Next Page
Loading...
