5.2.2 Connecting the device
Procedure
① Feed separator with integrated load ⑥ Safety catch
② Supply voltage ⑦ Process connection
③ Cable gland ⑧ Protective conductor connector/
equipotential bonding terminal
④ Connecting terminals ⑨ Ground terminal
⑤ Test connector for DC measuring device
Figure 5-3 Example: Electrical connection with feed separator
1. Connect the device to the system via the existing protective ground connection ⑧ by
observing the torques.
– Use a cable with a diameter of 1 … 4 mm
2
.
2. Insert the connecting cable through the cable gland ③.
Connecting
5.2 Connecting the device
SITRANS P320/P420 with 4 to 20 mA/HART
40 Compact Operating Instructions, 09/2018, A5E38874562-AB
To Next Page
Loading...
