Need help?Do you have a question about the Siemens 7MF4633 and is the answer not in the manual?
General| Product Type | Pressure Transmitter |
|---|---|
| Model | 7MF4633 |
| Manufacturer | Siemens |
| Communication Protocol | HART |
| Output Signal | 4 to 20 mA HART |
| Power Supply | 10.5 to 45 V DC |
| Housing Material | Stainless Steel |
| Protection Class | IP67 |
| Electrical Connection | M20 x 1.5 or 1/2 NPT |
| Operating Temperature | -40 to 85 °C |
| Accuracy | Typically ±0.075% of span |
| Process Connection | G1/2, 1/2 NPT, others available |
Describes how transmitters are configured before use.
Details how to connect the HART communicator to a transmitter loop.
Outlines the steps for performing a functional test on a test bench.
Describes how to connect and communicate with the transmitter.
Details how to perform a self-test on the transmitter.
Describes how to verify the transmitter's analog output.
Covers factors and calculations before mechanical and electrical installation.
Covers physical installation and conduit wiring.
Covers enclosure rotation and display orientation.
Details loop wiring for point-to-point and multi-drop networks.
Provides specific installation data for hazardous areas.
Verifies correct transmitter installation and specifications.
Shows how to connect equipment for system checkout.
Covers communication, error checks, and output verification.
Describes setting transmitter zero and adjusting shutoff valves.
Introduces local display and magnetic pushbuttons.
Explains operation using the HART Communicator.
Provides guidance for identifying and correcting malfunctions.
Details removal and replacement of assemblies.
Database downloaded to transmitter for operation.
Protocol for simultaneous analog/digital signaling.
Covers operation in hazardous areas with intrinsically safe circuits.
Details requirements for installing in Zone 0 hazardous areas.
To Next Page
