Updating, upgrading and expansion
40
11.4 Remove, move or replace wireless units
Sometimes there is a need for removal or replacement of wireless units. Some
measures must be taken while doing this.
11.4.1 Remove wireless units
The information about existing units and how they are logically built up in the radio
network exists both in PC and in different SR35i.
If a RF30-EM or RF9 are removed from the system, wait approximately 5 minutes
before deleting it from the Entro installation program. Otherwise the SR35i may
send the unit’s information to the PC again and it is once again (wrongly) displayed
in the list.
11.4.2 Replace or move wireless units
If e g a SR35i or RF9 are replaced or some RF9 or RF30-EM is moved some
commands must be performed in the SR35i both before and afterwards.
Read more in section 8.4.3 Further settings in the SR35i.
To Next Page
Loading...