English 04/00 BT 200
(S)J31069-D0075-U001-A2-6318Page 18
5 Log Mode
In log mode, performed tests are stored on
the BT 200. Later this information can be
transferred over a serial interface to a PC with
log SW.
Log mode can be enabled and disabled in the
SERVICE menu.
Log mode remains set even when the BT 200
is turned off. This mode remains on until the
setting in the SERVICE menu is changed
again.
An identifier (X0 ..X999) is assigned to each
test to be stored on the BT 200.
The following table shows the maximum
number of tests which can be stored and their
identifiers.
Type of Test ID Letter Max. Number
Wiring test V 128
Station test T 128
Branch test S 10
Distance meas. E 10
Reflection test R 10
Storing the tests
After each test, the following prompt with the
next available identifier appears on the dis-
play.
The identifier can be changed with the cursor
or accepted with OK.
If you manually enter an identifier which has
already been assigned, it will be overwritten.
To Next Page
Loading...
