Siemens CAB2-BD/-RD - Installing the Inner Door

Siemens Industry, Inc.
Building Technologies Division
P/N 315-033008-84
GROUND
STRAP
ON DOOR
Install the Inner Door: 1. Insert the hinge pins on the inner door in the hinges on the backbox. (Refer to
Figure 6.)
2. Insert blank plates, as needed, in unused spaces on door and secure with
10-32 nuts. (Refer to Table 1 and Figure 7.)
Models LVM and FMT, one module width each, mount to the inner door. No other
modules (PSC-12/PSX-12/CC-5/CC-2) may be located behind these modules.
Figure 5
Removing The 12AWG Ground Strap
Figure 6
Inserting Hinge Pins Into Inner Door Hinges
1ELBAT
SETALPROODRENNI
LEDOMNOITPIRCSEDGNITNUOM
PM-DI,6-MCFroftekcarb/etalpgnitnuoM
.MCBdna8-MCS,8-MCL
deruce
S.roodnisdutsnostnuoM
.stun23-01owthtiw
PS-DIehtsaezisemasehttresniknalB
.tekcarb/etalpgnitnuomPM-DI
deruc
eS.roodnisdutsnostnuoM
.stun23-01owthtiw
nacsPS-DIrosPM-DIruofotpU
.worenonodellatsnieb
PF-DI.etalpknalbwo
rlluFderuceS.roodnisdutsnostnuoM
.stun23-01thgiehtiw
MCB.etalpknalbroodrennIderuceS.roodnisdutsnostnuoM
.st
un23-01thgiehtiw