Siemens CB734G1 1 Series - 19 Rails; 19.1 Detaching the rails; 19.2 Attaching the rails

Rails en
23
5.
Note:When sliding the pane in, ensure that the
glossy side of the pane is on the outside and the
cut-outs on the left and right are at the top.
Slide the inner pane into the left- and right-hand
retainers ⁠.
6.
Push the inner pane upwards until it is in the left-
and right-hand retainers ⁠.
7.
Put the door cover into position ⁠ and push down
on it until you hear it click into place.
8.
Open the appliance door fully.
9.
Close the locking levers on the left- and right-hand
hinges ⁠.
a The locking levers are closed. The appliance door is
secured and cannot be detached.
10.
Close the appliance door.
Note:Do not use the cooking compartment again until
the door panes have been correctly fitted.
19 Rails
To thoroughly clean the rails and the cooking compart-
ment, or to replace the rails, you can remove the rails.
19.1 Detaching the rails
WARNING‒Risk of burns!
The shelf supports get very hot
▶ Never touch the shelf supports when hot.
▶ Always allow the appliance to cool down.
▶ Keep children at a safe distance.
1.
Lift the rail forwards slightly ⁠ and detach it ⁠.
2.
Pull the whole rail to the front ⁠ and remove it.
3.
Clean the rail.
19.2 Attaching the rails
Notes
¡ The rails only fit on the right or left.
¡ For both rails, ensure that the curved rods are at the
front.
1.
First, push the rail into the middle of the rear
socket ⁠ until the rail rests against the cooking
compartment wall, and then push this back ⁠.
2.
Push the rail into the front socket ⁠ until the rail
also rests against the cooking compartment wall,
and then press this downwards ⁠.