Need help?Do you have a question about the Siemens CERBERUS AlgoRex CT and is the answer not in the manual?
General| Battery Backup | Yes |
|---|---|
| Category | Fire Alarms |
| Power Supply | 230 VAC |
| Approvals | EN 54 |
| Operating Voltage | 24V DC |
Explains the symbols used for wiring diagrams and planning fire detection systems.
Defines key technical terms and abbreviations used in the document.
Illustrates a standard wiring diagram for a fire detection system.
Guidelines for installing and wiring collective detection lines in fire detection systems.
Describes planning and wiring for AnalogPLUS® detection lines in fire detection systems.
Covers installation and wiring requirements for interactive detection lines in fire detection systems.
Specifies requirements for alarm devices, including wiring and voltage drop considerations.
Details terminal connections and specifications for fire detection system components.
Covers low voltage mains and fire control installation requirements and cable compliance.
Explains how to interface fire detection systems with non-Cerberus systems.
References applicable standards, such as IEC 950, for fire detection systems.
Provides general information and responsibilities related to system installation.
Details the procedures and guidelines for mounting and installing fire detection equipment.
Describes the methods and tools for performing wiring checks on the fire detection system.
To Next Page