en Installation and connection
8
Before using the appliance for the first time
1. Remove information material, adhesive tape and
protective film.
2. Clean the appliance.
Electrical connection
Caution!
Do not connect the appliance to electronic energy saver
plugs.
Note:
You can connect the appliance to mains-controlled and
sine-controlled inverters.
Mains-controlled inverters are used for photovoltaic
systems which are directly connected to the national
grid. Sine-controlled inverters must be used for isolated
applications.Isolated applications, e.g. on ships or in
mountain lodges, which are not directly connected to
the national grid.
1. After installing the appliance, wait at least 1 hour
before connecting it to avoid damaging the
compressor.
2. Connect the appliance to a correctly installed
socket.
The socket must comply with the following data:
Outside Europe: Check whether the indicated
current type of the appliance corresponds with the
values of your power supply. The appliance
specifications are specified on the rating plate.
~ "Getting to know your appliance" on page 9
3. Connect the appliance to a socket near the
appliance.
The socket must also be freely accessible after
installation of the appliance.
:Warning
Risk of electric shock!
If the length of the mains cable is insufficient, do
NOT use multi-outlet power strips or extension
leads.Instead, please contact Customer Service for
alternative solutions.
Socket with 220 V ... 240 V
Protective conductor 50 Hz
Fuse 10 A ... 16 A
To Next Page
Loading...
