Siemens CL75 - Managing calls and conferences

© Siemens AG 2003, D:\Werkstatt\CL75 am fcc\S_WEGA_Phone.fm
21Calling
VAR Language: en; VAR issue date: 050210
left page (21) of S_Wega CL75 am, A31008-H1550-A40-1-7619 (10.03.2005, 14:32)
Swapping between
2calls b
Establish a second connection
§Hold§ Hold current call, then di-
al the new phone
number.
§Swap§ Swapping between calls.
Incoming calls during a call
You will hear a "knocking tone" and
you can now:
• Accept the waiting call in addition to
the first
§Swap§ Accept the call and put
the current call on hold.
• Reject the waiting call
§Reject§ Reject the call.
• Accept the waiting call and end the
current call
B
End a call.
C
Accept a new call.
End call(s)
B
Press the End key.
Conference b
You call 5 up to conference partici-
pants one after the other. Once you
have established a connection:
§Hold§ Select to put the current
call on hold.
J
Now dial a new
number.When the new
connection is established.
§Options§ Open menu and select
Conference. Repeat until
all participants are con-
nected.
End
B
When the End key is
pressed, all calls in the
multiparty conversation
are ended.
Tone sequences (DTMF)
Open phone book to select a number
to send as DTMF.
§Options§ Open menu and select
Send DTMF.