19 / 38
Siemens
Climatix HMI-TM CB1P3917en02
Building technologies 3BFunctions and operations 2015-07-02
If the application engineer configured that both the password of end user and
service user level could be changed, only Change factory password template
page will not be displayed and entered. Press and hold key ENTER on any page
(except the error report pages) and the log in/off page will be displayed:
For detail information about how to configure the password, refer to Climatix
SCOPE online help.
To change the password of user level, select Change user password and press
key ENTER, and the following page will be displayed:
If the entered passwords do not match, the following page will be displayed:
Then re-enter the password.
To Next Page
Loading...
Need help?
General
