To Next PageTo Next Page
Need help?Do you have a question about the Siemens CU240E-2 and is the answer not in the manual?
General| Digital Inputs | 6 |
|---|---|
| Digital Outputs | 3 |
| Analog Inputs | 2 |
| Protection Class | IP20 |
| Output Frequency | 0 - 650 Hz |
| Protection Features | Overvoltage, undervoltage, overcurrent, short circuit, overtemperature |
| Control Mode | Vector control, U/f control |
| Ambient Temperature | 0 - 50 °C |
General safety instructions to prevent personal injury and property damage.
Siemens products and solutions for secure operation against cyber threats.
Procedure for physically connecting the control unit to the power module.
Description of the various interfaces on the control unit.
Wiring examples and explanations for terminal strips on the CU240B-2 control unit.
Factory default settings for CU240B-2 interfaces based on fieldbus type.
Wiring examples and explanations for terminal strips on the CU240E-2 control unit.
Factory default settings for CU240E-2 interfaces based on fieldbus type.
Overview of operator panels and PC tools for commissioning the inverter.
Step-by-step guide for commissioning using the BOP-2 operator panel.
Procedure for performing a quick initial setup using the BOP-2 panel.
Settings for standard drive control application class.
Settings for dynamic drive control application class.
Process for identifying motor data and optimizing speed control.
Instructions and resources for connecting the inverter to fieldbus systems.
Explanation of commonly used parameters for inverter configuration.
List of additional manuals and guidelines for download.
Contact information and resources for technical support.
