Care and daily cleaning
Cleaning the milk system
The milk system is automatically cleaned
with a short jet of steam directly after pre-
paring a milk drink�
F
Tip: For particularly thorough clean-
ing, the milk system can be addi-
tionally rinsed with water (see the
section “Rinsing the milk system”).
Important: Clean the milk system
manually every week and, if
required, also more often (see the
section “Cleaning the milk system
manually”)�
B
Risk of burns!
The beverage outlet gets very hot�
After use, always let it cool down
before you touch it�
Rinsing the milk system
■ Press button E and select
“Rinse milk system” with the rotary
selector�
■ Press C to start the
programme�
■ Open door and remove suction pipe from
the milk tube�
■ Wipe the suction pipe and insert the end
of the suction pipe into the hole on the
coee grounds container�
■ Close the door� Be careful not to jam the
milk tube�
■ Place an empty glass underneath the
beverage outlet�
■ Press button C�
The milk system is rinsed with water�
■ Then empty the glass�
■ Press E to exit the program�
Cleaning the milk system manually
Take the milk system apart to clean it:
■ Push the beverage outlet down com-
pletely and pull the cover forward to
remove�
■ Press the snap lever to the left of the
beverage outlet downwards and pull the
beverage outlet forward�
■ Remove the milk tube. Dismantle the
top and bottom sections of the beverage
outlet�
■ Separate the milk tubes, connecting
element and suction pipe�
■ Clean the individual parts with a deter-
gent solution and a soft cloth�
■ Rinse all parts with clean water and dry
them�
To Next Page
Loading...
