Siemens CT636LE.1

48
en
Tips on energy saving
■ Pour lukewarm water into the empty
water tank up to the “0�5 l” mark and then
dissolve one Siemens descaling tablet
TZ80002 in it�
F
If there is not enough descaling
solution in the water tank, you will
be asked to do the following. Refill
using uncarbonated water and press
C again�
■ Remove the suction pipe from milk
container, wipe it and insert the end of the
suction pipe into the hole on the co󰀨ee
grounds container�
■ Close the appliance door�
■ Place a container with a capacity of
0�5 litre under the beverage outlet�
■ Press button C� The
programme will now run for about
19 minutes�
■ Remove the container and press
C�
■ Rinse the water tank and (if removed)
replace the water lter.
■ Fill the tank with fresh water up to the
“max” indicator�
■ Replace the water tank and close the
door�
■ Place the container underneath the bev-
erage outlet again�
■ Press button C� The
programme will now run for about
7 minutes and rinse the appliance�
■ Remove the container, empty the drip
trays, replace and close the appliance
door�
■ Press C� The appliance
is descaled, cleaned and ready for
use again�
■ Press E to exit the program�
Special rinsing
F
Important: If any of the service
programmes is ever interrupted, for
instance by a power failure, please
proceed according to the information
on the display:
■ Rinse the water tank and rell it with fresh
water up to the “max” mark�
■ Press button C� The
programme will now run for about
2 minutes and rinse the appliance�
■ Empty the drip trays, replace and close
the appliance door� The appliance is
ready for use again�
■ Press E to exit the program�
Tips on energy saving
■ Press button I to switch the
appliance to “energy saving mode”� The
appliances uses very little power when
in “energy saving mode”, but monitors all
safety-relevant functions so as to avoid
damage�
■ In the menu under “Switch off after”,
set the automatic switch o󰀨 period to
15 minutes�
■ Reduce the brightness of the display
and the illumination in the menu to save
energy�
■ If possible, do not interrupt the dispensing
of co󰀨ee or milk froth. Stopping a process
prematurely results in higher energy
consumption and the drip tray lls up
more quickly�
■ Descale the appliance regularly to avoid a
build-up of limescale� Limescale residues
cause higher energy consumption�
Frost protection
To prevent frost damage during trans-
port and storage, completely empty the
appliance beforehand (see the section
“Menu – Frost protection”)�