Siemens CT636LE.1

53
en
Technical specications
Problem Cause Solution
Display shows
“Empty drip trays”
despite them being empty�
Drip tray is soiled and wet� Clean and dry the drip tray
thoroughly�
Emptying is not detected
when the appliance is
switched o󰀨.
When the appliance is switched
on, remove and re-insert the
drip tray�
Display shows
“Insert drip trays” even
though drip tray in use�
Inside of appliance
(tray holder) dirty�
Clean the inside�
The co󰀨ee grounds container
is not fully inserted�
Push the co󰀨ee grounds
container all the way in�
Water dripped onto the
inner oor of the appli-
ance when the drip tray
was removed�
Drip tray was removed too
soon�
Wait a few seconds after the
last drink was dispensed before
removing the drip tray�
Display shows
“Please open door,
switch off with power
switch and then back on
after 30 sec!”
Appliance is too warm� Leave the appliance to cool
down�
Dirty brewing unit� Clean the brewing unit�
If you are unable to solve the problem, always call the hotline!
You will nd the telephone numbers at the back of these instructions.
Technical specications
Power connection (voltage – frequency) 220-240 V – 50/60 Hz
Power rating 1600 W
Maximum static pump pressure 19 bar
Maximum water tank capacity (without lter) 2�4 l
Maximum capacity of the co󰀨ee bean container 500 g
Length of power cable 1�7 m
Dimensions (H x B x D) 455 x 495 x 375 mm
Weight, empty 19-20 kg
Type of grinding unit Ceramic