EasyManua.ls Logo

Siemens CT636LE.1

Siemens CT636LE.1
116 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
52
en
Simple troubleshooting
Problem Cause Solution
Display shows
12:00
Power failure or appliance
switched o󰀨 at mains.
Reenter values; do not switch
the appliance o󰀨 at the mains
or select the “Offoption in the
Clock display menu�
Display shows
Milk container
connected?
despite connected milk
container
Container is outside the
range of the sensor
Position the container at the
right edge�
Material e�g� milk carton is
not recognised�
Conrm the display request with
Yes or use the enclosed milk
container
Display shows
“Overvoltage or
undervoltage”
Voltage too high or too low Contact electricity or grid pro-
vider� Have the power supply
checked by an expert�
Display shows
Leave device to cool
Appliance is too hot� Switch o󰀨 appliance for
30 minutes�
Display shows,
for example:
Fault: E0510
The appliance has a fault� Proceed according to the display
screen�
Display shows
Fill bean container
although the container is
already full, or the grinder
is not grinding any beans�
Beans are not falling into the
grinding unit (beans too oily)�
Gently tap the bean container
Possibly change the type of
co󰀨ee. When the bean container
is empty, wipe it with a dry cloth�
Display shows
“Clean brewing unit
Brewing unit is soiled� Clean the brewing unit�
Too much ground co󰀨ee in
the brewing unit�
Clean the brewing unit� Do not
place more than two level meas-
uring spoons of ground co󰀨ee in
the drawer
The mechanism of the
brewing unit is sti󰀨.
Clean the brewing unit, see
the section “Care and daily
cleaning”�
Display shows
Refill with still water or
remove filter ”
Water tank wrongly inserted Insert water tank correctly
Carbonated water in the
water tank�
Fill the water tank with fresh tap
water
Float is stuck in the water
tank�
Remove the tank and clean
thoroughly
New water lter not rinsed
according to instructions, or
water lter used or defective.
Rinse the water lter according
to the instructions and then
switch on, or use a new water
lter
Air in the water lter. Dip the water lter into water
until no more air bubbles
escape, replace the lter.

Table of Contents

Related product manuals