A5E32105880 ST-H Transducer – QUICK START MANUAL Page EN-11
mmmmm
English
Direct Connection
Connect the transducer directly to the Milltronics transceiver using the two conductor shielded
cable.
Coaxial Extension
Connect the transducer to the Siemens Milltronics transceiver via a junction box and RG–62 A/
U coaxial cable. This setup is effective for combined runs up to 365 m (1200 ft).
Note: When connecting to a SITRANS LUT400, a MultiRanger 100/200, or a HydroRanger
200, the white, black, and shield wires are all connected separately. DO NOT tie the white
and shield wires together.
Note: When connecting to a SITRANS LUT400, MultiRanger 100/200, and HydroRanger
200, do NOT use coaxial cable; see diagram below for proper procedure.
Extend cable using RG-62 A/U coax.
white
shield
To Next Page
Loading...
