Siemens EQ.500 classic - Dispensing Drinks with Milk Froth; Dispensing Coffee Drinks with Milk Froth; Dispensing Special Drinks; Dispensing Milk Froth

operation en
19
8.5 Dispensing drinks with
milk froth
You can use your appliance to dis-
pense coffee drinks with milk froth.
WARNING
Risk of burns!
The milk system can become ex-
tremely hot.
▶ Never touch the milk system when
it is hot.
▶ Allow the hot milk system to cool
down before touching it.
ATTENTION!
Milk residues can dry on surfaces
and are difficult to remove.
▶ Clean the milk system after every
use.
Tips
¡ You can also use plant-based al-
ternatives to milk, e.g. soya milk.
¡ The quality of the milk froth de-
pends on the type of milk or plant-
based alternative used.
8.6 Dispensing coffee drinks
with milk froth
Requirements
¡ The milk tube is connected.
¡ The suction pipe is connected.
1. Insert the suction pipe in the milk.
2. Place your pre-warmed cup under
the outlet system.
3. Press the symbol for a coffee drink
with milk.
a The display will show the drink and
your current settings.
→"Drink settings", Page20
4. Change the settings where neces-
sary:
‒ Use to adjust the amount.
→"Adjusting the amount",
Page21
‒ Use
to adjust the coffee
strength.
→"Adjusting the coffee
strength", Page20
‒ Use the ground coffee compart-
ment.
→"Dispensing a coffee drink
made from ground coffee",
Page18
5. Press
and wait until the process
is complete.
After preparing the drink, the milk
system will automatically clean it-
self with a short jet of steam.
Tip:If you want to stop the dispens-
ing process early, press . If you
want to stop the dispensing process
altogether, press ⁠.
8.7 Dispensing special drinks
Your appliance has other drinks be-
sides the ones that you can obtain
via the quick-selection buttons.
▶ Press
several times.
→"Drinks overview", Page13
8.8 Dispensing milk froth
WARNING
Risk of burns!
The milk system can become ex-
tremely hot.
▶ Never touch the milk system when
it is hot.
▶ Allow the hot milk system to cool
down before touching it.
Requirements
¡ The milk tube is connected.
¡ The suction pipe is connected.
1. Insert the suction pipe in the milk,
e.g. Tetra Pak carton.
2. Place your pre-warmed cup under
the outlet system.
3. Press
repeatedly until the dis-
play shows "Milk froth".