33
NEC, euroset 825 IM English: A30350-X102-X22-1-7619
22.1.97
825I-E2.FM
Using the telephone
If you want to use your telephone to transmit data, such as to control an answering
machine remotely, it has to be set to tone dialing. If it has been set to dial pulsing, you
will have to switch temporarily to tone dialing while a call is going on.
b
Let us assume you are in
the middle of a telephone
call and want to change the
dialing mode.
The phone number is shown
in the display.
>
Press the forward key.
In the display, you will see
"Tone dialing (DTMF) on?"
N
Confirm this.
The dialing mode is now
switched over.
After 1 second, you will see
"Tone dialing (DTMF) off?". in
the display.
o
Enter the relevant numbers
for the services (e.g. 1234).
N
To switch back to dial puls-
ing, confirm "Tone dialing
(DTMF) off?".
In the display, you will see:
"Tone dialing (DTMF) on?"
Note:
If your telephone is set to dial pulsing, you can also switch temporarily to tone dialing
by pressing the * key (see page 17). This temporary switchover does not affect the
basic dialing mode setting and the telephone automatically switches back to this
when you replace the handset.
Changing the dialing mode temporarily
Phone book?
123456
Tone dialing (DTMF) on?
123456
Tone dialing (DTMF) on!
Tone dialing (DTMF) off?
Tone dialing (DTMF) off?
1234
Tone dialing (DTMF) on?
To Next Page
Loading...
