Siemens EX875KYV1E - Page 13

Time-setting options en
13
10.2 Activating powerMove Plus
Requirement:Only place one item of cookware on a
FlexZone.
1.
Select one of the two cooking zones in the
FlexZone.
2.
Touch the active cooking mode.
3.
Select
⁠
a The function is switched on.
Note:You can change the power levels of the zones
during cooking.
10.3 Deactivating powerMove Plus
1.
Select a cooking zone.
2.
Touch the active cooking mode and switch to a dif-
ferent cooking mode.
a The function is switched off.
11 Time-setting options
Your hob has various functions for setting the cooking
time:
¡ Switch-off timer
¡ Timer
¡ countUp function
11.1 Switch-off timer
You can use this function to programme a cooking
time for one or more cooking zones. The cooking zone
is automatically switched off once the time that is set
has elapsed.
Switching on Switch-off timer
1.
Select the cooking zone and the power level.
2.
Touch
⁠ in the settings area.
3.
Set the cooking time in the settings area.
4.
Touch ⁠ to confirm.
a The cooking time begins to elapse.
a Once the cooking time has elapsed, the cooking
zone is switched off and a signal sounds.
Note:When you set a cooking time for a cooking zone
in which the fryingSensor is activated, the cooking time
will not start counting down until the selected temperat-
ure level has been reached.
Changing or switching off Switch-off timer
1.
Select the cooking zone and touch
⁠.
2.
Change the cooking time in the programming area
or touch ⁠ to delete the time.
3.
Touch ⁠ to confirm the selected setting.
4.
Touch the cooking zone display to return to the
main screen.
11.2 Timer
You can use this function to switch on a timer. This
function operates independently of the cooking zones
and other settings. It does not automatically switch off
the cooking zones.
Switching on Timer
1.
Touch
⁠.
2.
Select the required time in the programming area.
3.
Touch ⁠ to confirm the setting.
a The time starts to elapse.
a A signal tone sounds once the time has elapsed.
4.
Touch
⁠.
a The displays go out and the signal tone stops.
Changing or switching off the Timer
1.
Touch
⁠.
2.
Change the time in the programming area or touch
⁠ to delete the time.
3.
Touch ⁠ to confirm the selected setting.
4.
To return to the main view, touch ⁠.
11.3 countUp function
The stopwatch function displays the time that has
elapsed since activation.
Switching on countUp function
▶
Touch
⁠.
a The time starts to elapse.
Pause countUp function.
1.
Touch
⁠ in the main view.
2.
Touch ⁠.
a The stopwatch stops.
3.
Touch
⁠.
a The stopwatch continues to run.
Switching off countUp function
1.
Touch
⁠.
2.
Touch ⁠. The time display is set to 00 m 00 s.
To switch the time display on again, touch ⁠.
3.
To return to the main view, touch ⁠.