Siemens EX875KYV1E - Page 12

en flexInduction Plus
12
Notes
¡ You can change the default setting for the Flex
Zone. You can find out how to do this in the "Basic
settings" section →Page17.
¡ If you move or lift the item of cookware onto the act-
ive cooking zone, the cooking zone automatically
starts searching and the power level you selected
previously is retained.
8.3 flexInduction connect
▶
Touch
⁠.
a The cooking zones are connected to each other
and continue to work together.
9 flexInduction Plus
With the extended FlexZone, you can cook with larger
cookware or position long cookware sideways on.
The extension always switches on in conjunction with
one of the two FlexZones. You cannot switch the exten-
sion on separately.
9.1 Position the cookware according to
weight and size
Position the cookware in the middle over the rear part
of the flexible cooking zone and its extension.
Depending on the size of the cookware and the
covered cooking surface, you can switch on the flexible
cooking zone as two separate cooking zones or as one
connected cooking zone:
9.2 Activating flexInduction Plus
1.
Place the cookware on the cooking zone in such a
way that it is also on the extended FlexZone.
2.
Select the cooking zone and the power level. The
area of the extended FlexZone is shown on the dis-
play.
a The function is switched on.
Note:If the extended FlexZone is not shown on the dis-
play, lift the pan and place it on the cooking zone.
9.3 Deactivating flexInduction Plus
▶
Select the cooking zone and set it to to 0.
a The function is switched off.
10 powerMove Plus
You can use this function to change the power level for
an item of cookware by simply moving it within the
FlexZone. For this, the zone is divided into three areas
with different power levels.
10.1 Positioning and moving the cookware
Only use one item of cookware. The cooking area de-
pends on the cookware used, as well as its size and
positioning.
Each cooking area has a preset power level:
¡ Front section = power level 9.0
¡ Middle section = power level5.0
¡ Rear section = power level
⁠.
You can change the standard setting for the default
power levels. You can find out how to do this in the
"Basic settings" section →Page17.