45
Base station settings
Gigaset C300 / GRC EN / A31008-M2203-T101-1-8U19 / registr_sett.fm / 10.06.2010
Version 4, 16.09.2005
Base station settings
The base settings are carried out using a reg-
istered Gigaset handset.
Changing ringtones
u Volume:
You can choose between five volumes
and the "crescendo" ring (¢ page 43).
Select "0" to deactivate the base ringer.
u Ringtones:
You can set a ringer melody for external
calls (¢ page 43).
u Time control:
You can specify when the base should
not ring (e.g., during the night).
§Menu§ ¤ Settings ¤ Audio Settings
¤ Ringtones (Base) ¤ Ringer Volume /
Ringer Melody
/ Time Control
For more information on adjusting the set-
tings, see page 43.
Activating/deactivating
music on hold
§Menu§ ¤ Settings ¤ Tel eph ony
¤ Music on hold
Press
§OK§ to activate or deactivate music on
hold (³= on).
Activating repeater support
With a repeater, you can increase the range
and signal strength of your base. You will
need to activate repeater mode. This will ter-
minate any calls that are in progress at the
time.
Prerequisite: A repeater is registered.
§Menu§ ¤ Settings ¤ System
¤ Repeater Mode
Press
§OK§ to activate/deactivate repeater
mode (
³ = activated).
After activating or deactivating the
repeater, switch your handset off and
on again (¢ page 20).
Protecting against
unauthorised access
Protect the system settings of the base
station with a PIN known only to yourself.
The system PIN must be entered when,
for example, registering/de-registering a
handset to/from the base or when restoring
the default settings.
Changing the system PIN
You can change the 4-digit system PIN set on
the base (default setting: 0000) to a 4-digit
PIN known only by you.
§Menu§ ¤ Settings ¤ System ¤ System PIN
~ Enter the current system PIN
and press
§OK§.
~ Enter your new system PIN and
press
§OK§.
Please note
u Eco Mode / Eco Mode+ (¢ page 38)
and repeater support cancel each
other out, i.e., you cannot use Eco
Mode and Eco Mode+ when using a
repeater.
u The default encrypted transmission
setting is deactivated when a
repeater is activated.
To Next Page
Loading...
