EasyManua.ls Logo

Siemens Gigaset C380 - Initial Battery Conditioning

Siemens Gigaset C380
71 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12
First steps
Gigaset C380-C385 / IM English / A31008-M2007-R101-2-3T19 / starting.fm / 09.11.2010
Version 4, 16.09.2005
To charge the batteries, leave the handset in the charging cradle.
Should you have any questions and problems ¢ page 52.
Initial charging and discharging of batteries
The correct charge level can only be displayed if the batteries are first fully charged
and discharged.
Please note
u Each key press interrupts the automatic registration.
u If automatic registration does not work, the handset will have to be
registered manually (¢ page 42).
Please note
Only place the handset in the base station or charging cradle that is intended
for it.
Please note
u After the first battery charge and discharge you may replace your handset in
its base station or charging cradle after every call.
u Always repeat the charging and discharging procedure if you remove the
batteries from the handset and reinsert them.
u The batteries may warm up during charging. This is not dangerous.
u After a while, the charge capacity of the batteries will decrease for technical
reasons.
¤ Place the handset in the base station or charg-
ing cradle for eleven hours.
¤ Then remove the handset
from the base station or
charging cradle and do not
replace it until the batteries
are completely discharged.
11 h

Table of Contents

Related product manuals