Siemens GIGASET C470 IP - Preparing the Handset; Inserting the Supplied Batteries and Closing the Battery Cover; Connecting the Charging Cradle and Charging the Batteries

C470 IP KBA / GRC EN / A31008-M1916-T101-2-8U43 / install_3pg.fm / 2/23/09
Version 5, 23.09.2008
6 Preparing the handset
Inserting the supplied batteries and closing the battery cover
Connecting the charging cradle and charging the batteries
> Check the polarity when inserting the batter-
ies (see symbols in or on the battery com-
partment).
> Only use the recommended rechargeable
batteries.
Once the batteries have been inserted, the
handset switches on automatically.
Insert the battery compartment
cover into the notches at the top of
the battery compartment.
Then press the battery compart-
ment cover until it clicks into place.
> The display is protected by a plastic film. Please remove the protective film!
> Place the handset in the charging cradle and
wait until the batteries are fully charged.
> Do not put the handset back in the charging
cradle until the batteries are fully dis-
charged through use.
> After the first battery charge and discharge,
you may place your handset in the charging
cradle after every call.
> The battery charging status is displayed in
the idle display: = e V U (flat to full).
1
A
B
A
B
2
> Observe the
sequence (A, B)!
A
B