C470 IP KBA / GRC EN / A31008-M1916-T101-2-8U43 / install_3pg.fm / 2/23/09
Version 5, 23.09.2008
8 Connecting the base station
Connecting the base station with the router (Internet)
Connecting the PC to the router (optional)
Further configuration of the base station can be performed via a PC in the LAN.
> Connect the PC network connection to a free LAN socket on your router.
Connect one Ethernet cable plug to
the LAN socket at the side of the
base station.
Insert the second Ethernet cable plug
into a LAN socket on the router.
Use the Ethernet cable supplied.
As soon as the cable connecting the phone and router
is plugged in, the key lights up on the front of the base
station (paging key).
> The procedure below requires that your phone is automatically assigned an IP address
by the router (i.e. DHCP is enabled on router and phone).
In exceptional cases (e.g. if DHCP is not enabled on the router) you will have to assign
a static IP address to the base station for LAN access. You must enter this IP address on
the handset before carrying out the following steps. Further information can be found
in the user guide on the enclosed CD.
The following handset menu can be used to make the entry:
v ¢ Settings ¢ Base ¢ Local Network ¢ (Enter system PIN)
> VoIP should be set as the default line for your phone (default setting). You will then
immediately receive corresponding messages if a connection to the provider's VoIP
server cannot be established due to incorrect/incomplete data.
To Next Page
Loading...
Need help?
General
