EasyManua.ls Logo

Siemens Gigaset S670 - Appendix; Care; Contact with Liquid; Questions and Answers

Siemens Gigaset S670
78 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
58
Appendix
Gigaset S670/S675 / IM-MEA En / A31008-M1904-A601-1-3T19 / appendix.fm / 13.8.07
Version 4, 16.09.2005
Appendix
Care
¤ Wipe the base station, charging cradle
and the handset with a damp cloth (do
not use solvent) or an antistatic cloth.
Never use a dry cloth. This can cause a
build up of static.
Contact with liquid
If the handset has come into contact with
liquid:
1. Turn off the handset and remove the
batteries immediately.
2. Allow the liquid to drain from the hand-
set.
3. Pat all parts dry, then place the handset
with the battery compartment open
and the keypad facing down in a dry,
warm place for at least 72 hours (not
in a microwave, oven etc.).
4. Do not turn on the handset again un-
til it is completely dry.
When it has fully dried out, you will nor-
mally be able to use it again.
Questions and answers
If you have any questions about using
your phone, visit us at
www.siemens.com/gigasetcustomercare
at any time. The table below contains a list
of common problems and possible solu-
tions.
!
The display is blank.
1. The handset is not turned on.
¥ Press and hold the end call key a.
2. The battery is almost flat.
¥ Charge or replace the batteries (page 8).
The keys of a handset do not respond when
pressed.
The keypad lock is activated.
¥ Press and hold the hash key
#
(page 11).
"Base station x" flashes on the display.
1. The handset is outside the range of the base
station.
¥ Move the handset closer to the base sta-
tion.
2. The base station's range is reduced because
eco mode is activated.
¥ Deactivate eco mode (page 13) or
reduce the distance between the hand-
set and the base station.
3. The handset has been deregistered.
¥ Register the handset (page 42).
4. The base station is not turned on.
¥ Check the base station's mains adapter
(page 8).
Base Search flashes in the display.
The handset is set to Best Base and no base sta-
tion is turned on or within range.
¥ Move the handset closer to the base station.
¥ Check the base station's mains adapter
(page 8).
Handset does not ring.
1. The ringer tone is deactivated.
¥ Activate the ringer tone (page 50).
2. Call diversion set to All Calls.
¥ Deactivate call diversion.

Table of Contents

Related product manuals