58
Connecting the base to the PABX
Gigaset S790/S795 / USA-CAN EN / A31008-M2121-R301-1-3S19 / pabx.fm / 28.07.2009
Version 4, 16.09.2005
Connecting the base to the
PABX
The following settings are only necessary
if your PABX requires them; see the PABX
user guide.
Dialing modes and recall
The current setting is indicated by Ø.
Changing the dialing mode
The following dialing modes can be
selected:
u Tone dialing (DTMF)
u Pulse dialing (PD).
v ¢
Ï
¢ Telephony ¢ Dialing Mode
s Select dialing mode and press
§Select§ (Ø =selected).
Setting recall
Your phone is preset at the factory for
operation on the main connection. For
operation on a PABX, you may have to
change this value. Please refer to the user
guide for your PABX.
v
¢
Ï
¢ Telephony ¢ Flash
s Select recall and
press
§Select§
(
Ø = set value). Possible val-
ues are:
80 ms, 100 ms, 120 ms,
180 ms, 250 ms, 300 ms,
400 ms, 600 ms, 800 ms.
Setting pauses
Changing the pause after line seizure
You can change the length of the pause
that is inserted between pressing the talk
key c and sending the number.
v Open the main menu.
*#Q5#L
Press keys.
~ Enter number for the length of
the pause (1 = 1 sec.;
2 =3secs.; 3 = 7 secs.) and
press
§OK§.
Change pause after recall key
You can change the length of the pause if
your PABX requires this (refer to the user
guide for your PABX).
v Open the main menu.
*#Q5#2
Press keys.
~ Enter a number for the length
of the pause (1 = 800 ms;
2 =1600ms; 3 =3200ms)
and press
§OK§.
Switching temporarily to tone
dialing (DTMF)
If your PABX still operates with pulse dial-
ing (PD), but you need tone dialing for a
connection (e.g., to listen to the network
mailbox), you must switch to tone dialing
for the call.
Prerequisite: You are conducting a call or
have already dialed an external number.
* Press the star key.
After the call ends, pulse dialing is auto-
matically activated again.
To Next Page
Loading...
