EasyManua.ls Logo

Siemens Gigaset S790 - Handset Settings; Quick Access to Numbers and Functions

Siemens Gigaset S790
97 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
62
Handset settings
Gigaset S790-S795 / en Großbritannien / A31008-M2102-L101-2-7619 / registr_sett.fm / 29.03.2010
Version 4.1, 21.11.2007
Sensitivity:
Select noise level sensitivity (Low or
High).
¤ Press §Save§ to save the settings.
When the room monitor function is acti-
vated, the idle display appears as shown
below:
Changing the set destination
number
v ¢ É ¢ Room Monitor
¤ Enter and save number as described in
"Activating the room monitor and enter-
ing the destination number"
(
¢ page 61).
Cancel/deactivate room monitor
Press the end call key a to cancel the call
when the room monitor is activated.
In idle status, press the display key
§OFF§ to
deactivate room monitor mode.
Deactivating the room monitor
remotely
Prerequisites: The phone must support tone
dialling and the room monitor should be set
for an external destination number.
¤ Accept the call from the room monitor
and press keys 9 ;.
The room monitor function will deactivate
after the call ends. There are no further room
monitor calls. The other room monitor set-
tings on the handset (e.g., no ringtone) will
remain activated until you press the display
key
§OFF§ on the handset.
To reactivate the room function with the
same phone number:
¤ Turn on the activation again and save
with
§Save§ (¢page 61).
Handset settings
Your handset is preconfigured, but you can
change the settings to suit your individual
requirements.
Quick access to numbers and
functions
You can assign a number from the directory
to each of the digit keys Q and 2to
O.
The left and right display keys have a default
function. You can change the assignment
(
¢ page 63).
The number is then dialled or the function
started by simply pressing a key.
Assigning digit keys
Prerequisite: You have not yet assigned a
number to the digit key.
¤ Press and hold the digit key
or
Press the digit key briefly and press the
display key
§QuickDial§.
The directory opens.
¤ Select an entry and press §OK§.
The entry is saved to the corresponding digit
key.
i à V
07:15
INT 1 22 Oct
Á
Room Monitor
0891234567
OFF Options
Please note
If you delete or edit the entry in the direc-
tory at a later date, this will not affect the
assignment to the number key.

Table of Contents

Other manuals for Siemens Gigaset S790

Related product manuals