74
Gigaset S790-S795 / en Großbritannien / A31008-M2102-L101-2-7619 / appendix.fm / 29.03.2010
Version 4.1, 21.11.2007
Questions and answers
If you have any questions about the use of
your phone, you can contact us 24/7 at
www.gigaset.com/customercare
.
The table below contains a list of common
problems and possible solutions.
Gigaset S795 only:
The display is blank.
1. The handset is not switched on.
¥ Press and hold the end call key a.
2. The battery is empty.
¥ Charge the battery or replace it
(
¢page 12).
Not all menu items are displayed.
The menu display is restricted (standard mode).
¥ Activate extended menu display
(expert mode
•
) (¢page 25).
No Base flashes on the display.
1. The handset is outside the range of the base.
¥ Move the handset closer to the base.
2. The base's range is reduced because
Eco Mode is activated.
¥ Deactivate Eco Mode (¢ page 54) or
reduce the distance between the handset
and the base.
3. The base is not switched on.
¥ Check the base power adapter
(
¢page 10).
Please register handset flashes on the display.
Handset has not been registered with the base or
has been deregistered.
¥ Register the handset (¢page 58).
Handset does not ring.
1. The ringtone is deactivated.
¥ Activate the ringtone (¢page 66).
2. Call divert set for "All Calls".
¥ Deactivate call divert (¢page 31).
3. The phone only rings if the phone number
has been transferred.
¥ Switch on the ringtone for unknown calls
(
¢page 66).
You cannot hear a ringtone/dialling tone from
the fixed line network.
The phone cord supplied has not been used or
has been replaced by a new cord with the wrong
pin connections.
¥ Please always use the phone cord supplied or
ensure that the pin connections are correct
when purchasing from a retailer
(
¢page 10).
Error tone sounds after system PIN prompt.
You have entered the wrong system PIN.
¥ Reset the system PIN to 0000 (¢page 70).
Forgotten the system PIN.
¥ Reset the system PIN to 0000 (¢page 70).
The other party cannot hear you.
You have pressed the mute button h. The
handset is "muted".
¥ Reactivate the microphone (¢ page 29).
The number of the caller is not displayed
despite CLIP.
Calling Line Identification is not enabled.
¥ The caller should ask the network provider to
enable Calling Line Identification (CLI).
You hear an error tone when keying an input (a
descending tone sequence).
Action has failed/invalid input.
¥ Repeat the operation.
Watch the display and refer to the user guide
if necessary.
You cannot listen to messages on the network
mailbox.
Your PABX is set for pulse dialling.
¥ Set your PABX to tone dialling.
No time is specified for a message in the call list.
Date and time have not been set.
¥ Set the date and time (¢ page 15).
The answering machine announces "PIN is
incorrect" during remote operation.
1. You have entered the wrong system PIN.
¥ Enter the system PIN again.
2. The system PIN is still set to 0000.
¥ Set the system PIN to something other
than 0000 (
¢page 70).
To Next Page
Loading...
