Information and Communication Mobile
Confidential 6 ICM MP CCQ GRM C
J. Junggebauer
Version 1.1 October 2003
* Read customer settings (menu, 8918):
Menu for Hotline purposes that enables to check some customer settings in 1
procedure. Instead of asking the customer which flash time…he has said he just
needs to tell the Hotline this special code.
Example: 012XXX - 1 - 1 - 3
The first 6 characters show the registered handsets from 1 to 6 with authorisation.
Authorisation: 0 = external and internal (no barring)
1 = external incoming
2 = internal only
X = not subscribed
In this case (021XXX) it means that 3 handsets are registered on the base
station.
Handset 1 is not barred, handset 2 can only accept external calls and can be
used for internal calls. Handset 3 can be only used for internal calls.
The 1 indicates the repeater mode: 0 = off
1 = on
The 1 stands for the dial mode: 1 = DTMF
2 = Dial pulsing
3 = DTMF + Earth
The 3 stands for the flash time: 0 = 80 ms
1 = 100 ms
2 = 120 ms
3 = 180 ms
4 = 250 ms
5 = 300 ms
6 = 600 ms
7 = 800 ms
** Working time
(menu, 8971):
Read out the time for which the base station has been switched on.
Example: 15d, 10h means handset has been switched on for 15 days and 10 hours.
The counter's max. value is 65535 hours or 2730 days. It can only be reset at WSC.
Fundamental reset:
Disconnect mains. Press paging key on base station and hold down.
Plug in AC- adapter. Hold key pressed for more than 3 seconds.
Release paging key. The base station is now set to factory defaults.
The system-PIN is reset to 0000 and all mobile units are deregistered.
If a handset was registered only to this base station before the reset, it can be
registered automatically after a location update with the base station (after appr.
30 seconds or after picking up the handset (off hook key).
To Next Page
Loading...
