EasyManuals Logo

Siemens HM936GC.1 Series User Manual

Siemens HM936GC.1 Series
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #32 background imageLoading...
Page #32 background image
en Disposal
32
Fault Cause and troubleshooting
Appliance does not
heat up.
There has been a power cut.
Open and close the appliance door once after a power failure.
a The appliance is checked and is ready to use.
The time is not dis-
played when the ap-
pliance is switched
off.
Basic setting has been changed.
Change the basic setting for the time display.
→"Basic settings", Page23
HomeConnect is not
working properly.
Different causes are possible.
Go to www.home-connect.com.
During simple mi-
crowave operation,
the cooking compart-
ment becomes hot.
The drying function is switched on.
To prevent condensation from forming when the appliance is in microwave-only mode, the
appliance automatically switches on an additional heating element when it is set to 600W
or 800W. The cooking result is not affected by this.
You can change the basic setting for the drying function during microwave operation.
→"Basic settings", Page23
Observe the information on operating with microwave.
→"Microwave", Page16
The interior lighting
does not work.
Basic setting has been changed.
Change the basic setting for the lighting.
→"Basic settings", Page23
The LED light is defective.
Call the after-sales service.
→"Customer Service", Page33
Maximum operating
time reached.
To prevent an unwanted permanent operation, the appliance automatically stops heating
after several hours if the settings are unchanged. A message appears in the display.
The point at which the maximum operating time is reached is determined by the corres-
ponding settings for an operating mode.
1.
To continue operation, switch the appliance off and on again using . Reset and start
the operation.
2.
If you do not need to use the appliance, press to switch it off.
Tip:To prevent the appliance from switching off when you do not want it to, set a cooking
time.
→"Time-setting options", Page15
Error code made up
of letters and num-
bers appears on the
display, e.g. E0111.
The electronics have detected a fault.
1.
Switch the appliance off and on again.
a If the fault was a one-off, the message disappears.
2.
If the message appears again, call the after-sales service. Please specify the exact error
message when calling.
→"Customer Service", Page33
The cooking result is
not satisfactory.
Settings were unsuitable.
Adjustment values, e.g. temperature or cooking time, depend on the recipe, quantity and
food.
Next time, set lower or higher values.
Tip:A lot of other information about the food preparation and corresponding adjustment
values can be found in the HomeConnect app or on our website siemens-home.bsh-
group.com .
25  Disposal
25.1 Disposing of old appliance
Valuable raw materials can be reused by recycling.
1.
Unplug the appliance from the mains.
2.
Cut through the power cord.
3.
Dispose of the appliance in an environmentally
friendly manner.
Information about current disposal methods are
available from your specialist dealer or local author-
ity.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens HM936GC.1 Series and is the answer not in the manual?

Siemens HM936GC.1 Series Specifications

General IconGeneral
BrandSiemens
ModelHM936GC.1 Series
CategoryOven
LanguageEnglish

Related product manuals