Siemens I-T-E Sensitrip MD Series - Page 37

I-T-E Internal Accessories
35
Figure 3
C. Check handle for proper fit on handle arm. Replace load
end cover and cover screws. (quantity 8)
Replace All Covers and Shields
A. Add two labels to circuit breaker Attach internal acces-
sory ID label (16) (Figure 4) to top of circuit breaker on right
hand side. Make sure it is located in the proper space on
existing label. Attach wiring label (17) on side of circuit
breaker cover as shown
NOTE: This accessory is suitable to use for Ground Fault
Protection when combined with Class I Ground Fault
Sensing Element equipped with internal clearing switch .
Figure 4