Siemens iQ300 GU21N Series - Basic Operation; Switching On the Appliance; Setting the Temperature

en Basic operation
14
1. Fill the ice cube tray with drinking
water up to ¾ and place in the
freezer compartment.
If the ice cube tray is stuck to the
freezer compartment, loosen it with
a blunt object such as the handle
of a wooden spoon.
2. To loosen the ice cubes, twist the
ice cube tray slightly or hold it
briefly under flowing water.
Basic operation
7 Basic operation
Basic operation
7.1 Switching on the appli-
ance
1. Electrically connect the appliance.
→Page11
Note:If the appliance has been
previously switched off using the
control panel, press and hold ⁠
for threeseconds.
a The temperature display shows an
animation and the control panel is
locked.
a The appliance is ready to use once
the animation has ended and an
LED lights up for the temperature
display.
a The appliance begins to cool.
a A warning signal sounds and the
temperature display flashes be-
cause the freezer compartment is
still too warm.
2. Switch off the warning tone using
.
a The temperature lights up as soon
as the set temperature is reached.
3. Set the required temperature.
→Page14
7.2 Operating tips
¡ Once you have switched on the
appliance, the set temperature is
only reached after several hours.
Do not put any food in the appli-
ance until the set temperature has
been reached.
¡ When you close the door, a va-
cuum may be created. The door is
then difficult to open again. Wait a
moment until the vacuum is offset.
¡ The temperature in the appliance
varies due to the following condi-
tions:
– How often the appliance is
opened
– Load capacity
– Temperature of newly stored
food
– Ambient temperature
– Direct sunlight
7.3 Switching off the appli-
ance
▶ Press and hold ⁠ for 3seconds.
7.4 Setting the temperature
Setting the freezer compartment
temperature
▶ Press repeatedly until the tem-
perature display shows the re-
quired temperature setting.
The recommended temperature in
the freezer compartment is
−18°C.