Siemens iQ300 KU22L Series - 8.2 Sabbath Mode; 9 Alarm System; 9.1 Door Alarm; 10 Home Connect

en Alarm
16
In order to utilise the freezing capa-
city, use the Super function.
→"Freezing capacity", Page20
Note:When the Super function is
switched on, increased noise may
occur.
Switching on Super function
▶ Press repeatedly until lights
up.
Note:After approx. 24hours, the ap-
pliance switches to normal operation.
Switching off Super function
▶ Press repeatedly until the tem-
perature display shows the re-
quired temperature.
8.2 Sabbath mode
To ensure that you can also use the
appliance on the Sabbath, the Sab-
bath mode switches off all non-es-
sential functions.
During Sabbath mode, the following
functions are switched off:
¡ Alarm
¡ Interior lighting
¡ Signal tones
¡ Messages on the control panel
Note:The brightness of the control
panel lighting is reduced during the
Sabbath mode.
Switching on Sabbath mode
▶ Press and hold for 15seconds
until an audible signal sounds.
a lights up.
Note:After approx.80hours, the ap-
pliance switches to normal mode.
Switching off Sabbath mode
▶ Press and hold for 15seconds
until an audible signal sounds.
Alarm
9 Alarm
Alarm
9.1 Door alarm
If the appliance door is open for a
while, the door alarm switches on.
A warning tone sounds and lights
up.
After 10 minutes, the interior lighting
flashes.
Switching off the door alarm
▶ Close the appliance door or press
.
a The warning tone is switched off.
HomeConnect
10 HomeConnect
HomeConnect
This appliance is network-capable.
Connect your appliance to a mobile
device to control its functions via the
HomeConnect app.
The HomeConnect services are not
available in every country. The avail-
ability of the HomeConnect function
depends on the availability of
HomeConnect services in your coun-
try. You can find information about
this at: www.home-connect.com.
To be able to use HomeConnect,
you must first set up the connection
to the WLAN home network (Wi-Fi
1
)
and to the HomeConnect app.
After switching on the appliance, wait
at least 3minutes until internal
device initialisation is complete. Only
then should you set up HomeCon-
nect.
The HomeConnect app guides you
through the entire login process. Fol-
low the instructions in the HomeCon-
nect app to configure the settings.
1
Wi-Fi is a registered trademark of the Wi-Fi Alliance.