Siemens iQ300 KU22L Series - 16 Troubleshooting; Appliance Not Cooling (Displays Lit); LED Lighting Failure; Home Connect Connectivity Issues

en Troubleshooting
24
Troubleshooting
16 Troubleshooting
Troubleshooting
You can rectify minor faults on your appliance yourself. Read the troubleshoot-
ing information before contacting after-sales service. This will avoid unneces-
sary costs.
WARNING
Risk of electric shock!
Improper repairs are dangerous.
▶ Repairs to the appliance should only be carried out by trained specialist
staff.
▶ Only use genuine spare parts when repairing the appliance.
▶ If the power cord or the appliance power cable of this appliance is damaged,
it must be replaced with a special power cord or special appliance power
cable, which is available from the manufacturer or its Customer Service.
Fault Cause and troubleshooting
The appliance is not
cooling, the displays
and lighting are lit.
Showroom mode is switched on.
1. Disconnect the appliance from the mains.
Unplug the appliance from the mains or switch off
the circuit breaker in the fuse box.
2. Wait 2minutes.
3.
Reconnect the appliance. →Page11
4. Press and hold until 4 audible signals have soun-
ded.
5. After a short time, check whether your appliance is
cooling.
The LED lighting does
not work.
Different causes are possible.
▶ Call customer service.
The customer service number can be found in the
enclosed customer service directory.
HomeConnect is not
working properly.
Different causes are possible.
▶ Go to www.home-connect.com.
The warning tone
sounds.
The door alarm is
switched on.
The appliance door is open.
▶ Close the appliance door.