operation en
13
operation
7 Basic operation
operation
7.1 Switching on the appli-
ance
1. Press .
a The appliance begins to cool.
a A warning signal sounds and the
temperature display flashes be-
cause the freezer compartment is
still too warm.
2. Switch off the warning tone using
.
a The temperature lights up as soon
as the set temperature is reached.
3. Set the required temperature.
→Page13
7.2 Operating tips
¡ Once you have switched on the
appliance, the set temperature is
only reached after several hours.
Do not put any food in the appli-
ance until the set temperature has
been reached.
¡ The front and top panels of the
housing are temporarily heated
slightly. This prevents condensa-
tion in the area of the door seal.
¡ When you close the door, a va-
cuum may be created. The door is
then difficult to open again. Wait a
moment until the vacuum is offset.
7.3 Switching off the appli-
ance
▶ Press .
7.4 Setting the temperature
Setting the freezer compartment
temperature
▶ Press repeatedly until the tem-
perature display shows the re-
quired temperature.
The recommended temperature in
the freezer compartment is
−18°C.
8 Additional functions
8.1 Automatic Super freezing
With automatic Super freezing, the
freezer compartment cools down to a
much lower temperature than in nor-
mal mode. This freezes food more
quickly.
The automatic Super freezing
switches on if you place fresh food in
the top frozen food container, starting
from the right-hand side.
If the automatic Super freezing is
switched on, lights up and in-
creased noises may occur.
After operation, the appliance
switches from automatic Super freez-
ing to normal operation.
Cancelling automatic Super
freezing
▶ Press repeatedly until the tem-
perature display shows the re-
quired temperature.
8.2 Manual Super freezing
With Super freezing, the freezer com-
partment cools as cold as possible.
Switch on Super freezing four to
sixhours before placing food weigh-
ing 2kg or more into the freezer
compartment.
To Next Page
Loading...
