Siemens iQ700 CM924G1 1B Series - 17.2 Cleaning the cooking compartment after using the cleaning aid; 18 Drying function; 18.1 Drying the cooking compartment; 18.1.1 Setting the drying process

en Drying function
24
5.
Press ⁠.
a A notification stating that you should carry out the
necessary preparatory work for the cleaning aid ap-
pears on the display.
6.
Confirm the notification.
a The cleaning aid starts and the cooking time counts
down.
a Once the cleaning aid has ended, a signal tone
sounds. A notification appears on the display con-
firming that the operation has finished.
7.
Press to switch the appliance off.
8.
→"Cleaning the cooking compartment after using
the cleaning aid", Page24.
17.2 Cleaning the cooking compartment
after using the cleaning aid
ATTENTION!
The prolonged presence of moisture in the cooking
compartment leads to corrosion.
▶ After using the cleaning assistance, wipe the cook-
ing compartment and allow it to dry completely.
1.
Allow the appliance to cool down.
2.
Wipe out the remaining water in the cooking com-
partment using an absorbent sponge cloth.
3.
Clean the smooth enamel surfaces in the cooking
compartment with a dish cloth or a soft brush. Re-
move stubborn food remnants using a stainless
steel scouring pad.
4.
Remove limescale with a cloth soaked in vinegar,
and wipe this away with clean water.
5.
Dry the cooking compartment with a soft cloth.
6.
To dry the cooking compartment completely, leave
the appliance door open for approx.1hour or use
the "Drying" function.
→"Setting the drying process", Page24
Drying function
18 Drying function
To prevent residual moisture, dry the cooking compart-
ment following microwave-only operation.
ATTENTION!
If there is water on the cooking compartment floor
when operating the appliance at temperatures above
120°C, this will damage the enamel.
▶ Do not use the appliance if there is water on the
cooking compartment floor.
▶ Wipe away any water on the cooking compartment
floor before operation.
18.1 Drying the cooking compartment
You can dry the cooking compartment by hand or use
the "Drying function" function.
1.
Allow the appliance to cool down.
2.
Remove dirt from the cooking compartment.
3.
Wipe away the water in the cooking compartment.
4.
Dry the cooking compartment.
‒ To dry the cooking compartment, leave the appli-
ance door open for 1hour.
‒ To use the "Drying function" function, set "Drying
function".
→"Setting the drying process", Page24
Setting the drying process
Requirement:→"Drying the cooking compartment",
Page24
1.
Press "Cleaning".
2.
Press "Drying function".
The duration cannot be changed.
3.
Press ⁠.
a A notification stating that you should carry out the
necessary preparatory work for the drying appears
on the display.
4.
Confirm the notification.
a The drying process starts and the duration counts
down.
a Once the drying has ended, a signal tone sounds. A
notification appears on the display confirming that
the operation has finished.
5.
Press to switch the appliance off.
6.
To dry the cooking compartment completely, leave
the appliance door open for 1 to 2minutes.
Appliance door
19 Appliance door
To clean the appliance door thoroughly, you can disas-
semble the appliance door.
19.1 Detaching the door outer pane
WARNING‒Risk of injury!
The hinges on the appliance door move when the door
is opened and closed, which could trap your fingers.
▶ Keep your hands away from the hinges.
Components inside the appliance door may have sharp
edges.
▶ Wear protective gloves.
1.
Open the appliance door.
2.
Place a folded-up tea towel in the appliance door.