Installation and connection en
11
volume of refrigerant is indicated
on the rating plate. →"Appliance",
Fig. 1 /
, Page14
The weight of the appliance ex works
may be up to 155kg depending on
the model.
The subfloor must be sufficiently
stable to bear the weight of the appli-
ance.
Permitted room temperature
The permitted room temperature de-
pends on the appliance's climate
class.
The climate class can be found on
the rating plate. →"Appliance", Fig.
1 /
, Page14
Climate
class
Permitted room tem-
perature
SN 10°C to 32°C
N 16°C to 32°C
ST 16°C to 38°C
T 16°C to 43°C
The appliance is fully functional within
the permitted room temperature.
If an appliance with climate class SN
is operated at colder room temperat-
ures, the appliance will not be dam-
aged up to a room temperature of
5°C.
Over-and-under and side-by-side
installation
If you want to install 2 refrigerating
appliances one over the other or side
by side, you must maintain a clear-
ance of at least 150mm between the
appliances. Selected appliances can
be installed without a minimum clear-
ance. Ask your dealer or kitchen
planner about this.
4.3 Installing the appliance
▶ Install the appliance in accordance
with the enclosed installation in-
structions.
4.4 Preparing the appliance
for the first time
1. Remove the informative material.
2. Remove the protective foil and
transit bolts, e.g. remove the ad-
hesive strips and carton.
3. Clean the appliance for the first
time. →Page31
4.5 Connecting the appliance
to the drinking water con-
nection
Requirements
¡ A corner valve must be installed
on the water connection and be
freely accessible following installa-
tion of the appliance.
¡ The water connection is checked
and is of drinking water quality.
1. Rinse the drinking water connec-
tion thoroughly until the drinking
water is no longer cloudy and con-
tains no deposits.
If the drinking water is still cloudy
or contains deposits, install an ex-
ternal water filter system.
2. Install the drinking water connec-
tion according to the enclosed in-
stallation instructions.
4.6 Connecting the appliance
to the electricity supply
1. Insert the non-heating appliance
plug of the power cable into the
appliance.
2. Insert the mains plug of the appli-
ance's power cable in a socket
nearby.
To Next Page
Loading...
Need help?
General
