Siemens Iq700 KF96D Series - 13.2.2 Dispensing ice or water; 13.2.3 Bottle fill option; 13.2.3.1 Filling a bottle; 13.2.3.2 Setting the amount of water for the bottle fill option

Water system en
29
Dispensing ice or water
1. To activate setting mode, touch the
lower area of the control panel.
2. Press the required selection op-
tion and press the glass against
the dispensing button ⁠.
Tip:Hold the glass directly under
the dispenser opening.
Notes
¡ After a while of continuous dis-
pensing, the ice or water stops
being dispensed. Wait a few
seconds before dispensing ice
or water again.
¡ After ice or water has been dis-
pensed several times consecut-
ively, it stops being dispensed.
Wait a few minutes before dis-
pensing ice or water again.
¡ When changing from ⁠cubes to
⁠crushed, a few ice cubes may
be released the next time you
dispense.
¡ When changing from ⁠crushed
to ⁠cubes, a small amount of
crushed ice may be released
the next time you dispense.
Bottle fill option
You can dispense a specific amount
of water with the bottle fill option.
Note:The factory-set amount of water
is approx. 900ml.
Filling a bottle
1. Press ⁠bottle.
2. Place a bottle or jug under the dis-
penser opening.
3. Press ⁠bottle.
a The set amount of water is dis-
pensed.
Tips
¡ To stop dispensing early, press
any touch field on the control
panel.
¡ To start dispensing again, press
⁠bottle.
Note:If you do not fill a bottle for
some time, the selection option
changes to ⁠water.
Setting the amount of water for the
bottle fill option
Note:The maximum fill time is
60seconds.
1. Press ⁠bottle.
2. Place a bottle or jug under the dis-
penser opening.
3. Select one of the options:
‒ Press and hold ⁠bottle at the
same time until the desired
amount of water is dispensed.
‒ Press / ⁠(Freezer compart-
ment) repeatedly until the tem-
perature display (freezer com-